Cone crusher rock crusher rock breaker stone break (China)

Cone crusher



We are sand making machines and stone making line manufacturer from China, can supply different capacity of sand making machine and stone making machine depending on your different requirements. The jaw crusher and impact crusher is the main shredders for the sand producing line and stone producing line. The machines for this sand and stone making line incluide: belt conveyor, vibrating feeder, jaw crusher, impact crusehr, cone crusher, vibrating screen, etc. you can also choose hammer crusher,roller crusher, shredders,vertical combination crusher, oscillating screen, V-series super fine crusher,hamemr mill and so on stone breakers.

Cone crusher is suitable to crush various kinds of ores and rocks of medium or above medium hardness. Compare with jaw crusher, cone crusher is of stable structure, high efficiency, easy adjustment, and use economically, etc. The spring safety system of crusher acts as an overloading protection system that allows metals to pass through the crushing chamber so as not to damage the cone crusher. The safety system uses dry oil and water as two kinds of sealed formation to make plaster powder and engine oil separated to make sure reliable performance. The type of crushing chamber depends upon the size of feeding and fineness of the crushed product. The standard type(PYB) is applied to medium crushing, the medium type is applied to medium or fine crushing and the short head type is applied to fine crushing.

Working Principle:

Cone crusher crushes materials by the working surface between the movable cone and fixed cone. So it is more advanced and efficiency than jaw crusher. The movable cone is supported by spherical bearing and fixed on a hanging erect shaft which is set in the eccentric sleeve, and the sleeve is set on the stopping and pushing bearing. The movable cone and erect shaft are droved by the eccentric shaft sleeve together. The eccentric shaft sleeve is driven by horizontal shaft and fimbriated gear, and the wheel of the conveyor belt is droved by motor through v-belts. The lower part of vertical shaft is installed in the eccentric sleeve. When the eccentric sleeve rotates, there is a conical surface lined out by the shaft. When the movable cone comes near the fixed cone, rocks are grinded into pieces, when the cone leaves, grinded materials is discharged from the discharging hole. The fixed cone can be ascended or descended by adjusting setting to adjust the width of discharge hole, consequently the output size is determined.

pls check our web to get the detail information.

www dot chinesecrusher

Attn: Mr Ding

Mob:0086- 15903624859

Skype: zkmachine

E-mail: zkmachinery at

Msn: zkmachinery at